Maxview MXL002/TWIN Bedienerhandbuch PDF herunterladen (Seite 12)

Attaching Antenna Mount Plate & LNB Park Plate

1. Remove antenna unit from wooden transit packaging.

2. Remove mounting plate from Antenna Unit by removing 6 x M6 nuts using 10mm

spanner.

3. Clean roof, Mounting Plate and LNB Park Plate in accordance with adhesive

manufacturer’s guidelines.

4. Mark a centre line for the antenna making sure dish will not overhang vehicle.

5. Align notches on plate with centre line.

6. Mark the position of 6 screw fixing holes and centre hole.

7. Mark position of LNB Park Plate.

8. Drill 6 x 2.5mm pilot holes into the roof

9. Apply adhesive to entire surface of Antenna Mounting Plate and LNB Park Plate and

firmly place them into position.

10. Place a small amount of adhesive into each hole before screwing plate to roof.

11. Wipe off excess adhesive with a cloth.

Note

• Follow manufacturer’s instructions when applying adhesive. Do not travel until

adhesive has cured noting that curing times vary with weather conditions.

• Take care when working at heights. Always follow ladder manufacturer’s safety

advice.

• Use creeper boards where necessary to ensure roof construction can support your

weight.

• Power tools should be used in accordance with manufacturer’s instructions.

Direction of travel

Centre Line

LNB Park Plate

Antenna Mount Plate

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Keine Kommentare

Maxview MXL002/TWIN Bedienerhandbuch Seite 12